Beta FPV Betaflight F3 Brushed Flight Controller+OSD

OSD付きのTiny Whoop用のBETAFLIGHT F3フライトコントローラー!
OSD画面上から送信機を使ってPIDなどを変更調整可能です
MPUがアップグレードされ、より反応が良くなりました
ブザーポートも付属!
本格的なドローンレーサーと同じモード設定できます!
モーターコネクター付きでモーターの交換も簡単です
※受信機は別途取り付けてください
※バッテリーコネクターはPH2.0となります

Bullet Points
The world's first compatible BetaFlight OSD, BetaFlight firmware, born for acro F3 flight controller for the Micro Whoop or Blade Inductrix quadcopter.
Fully programmable through Betaflight, using the onboard USB port, tune all the parameters, PID's, and rates to your perfect settings.
5V, 3.3V, UART2, PPM ports are leaved for external micro receivers. Recommended micro receivers include Frsky XM / XM+, FuriousFPV LR1000, Lemon DSMX receiver, Flysky X6B etc.
Buzzer port is leaved for micro beeper. You could find your crashed drone easily with this beep function.
The flight controller board comes pre-flashed with Betaflight firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2.0 connector, AKA Power
Specifications
CPU: STM32F303CCT6
Six-Axis: MPU6000
Size: 26mm x 26mm, fully compatible with the Inductrix quad frame and mounting pattern
Firmware version: Betaflight BETAFLIGHTF3 3.1.7
Receiver interface: 5V, 3.3V, UART2 and PPM
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Power Cable: 55mm, with JST-PH 2.0 connector, AKA PowerWhoop connector
Weight: 3.0g

Package
1 * F3 OSD brushed flight controller (No receiver version, 55mm PH-JST 2.0 power cable soldered)
4 * M1.2x4mm screws (Fit for stock Inductrix frame)
4 * M1.4x5mm screws (Fit for Beta75 etc 75mm frame)
4 * Anti-vibration ruber dampers
1 * 55mm PH-JST 1.25 power cable pigtailWhoop connector.
型番 01-187
販売価格
3,500円(税259円)
購入数